Table of Contents
Advertisement
→ Specification
Item
Output mode
Frequency
Voltage level
Max output current
Max leakage current when off
Respond time to conduct
Respond time to close
Overcurrent protection
Isolation method
Note:
The times in the form are typical based on the resistive load, and may change
when the load circuit changes.
Due to the leak-type output, the shutdown of the output will be obviously affected
by the external load circuit, and the output frequency should not be set too high in
the application. It is recommended to be lower than 8HKz. If there needs higher
speed, please contact us to adjust parameter or custom hardware.
→ Wiring Reference
Low Speed Output (OUT0-7)
NPN leakage type, it is 0V when outputs
＜8kHz
DC24V
+300mA
25μA
12μs
80μs
Support
optoelectronic isolation
Advertisement
Table of Contents
