Table of Contents
Advertisement
INPUT MODES
The same input modes are available for IN E/F and META IN.
You will cycle thru these different modes:
REGULAR: affects the position of the RATE knob
●
(LFO+ENV lights ON)
REGULAR ATTENUATED: affects the position of the
●
RATE knob, but less
(LFO+ENV lights dimmed)
INVERTED: inversely affects the position of the
●
RATE knob (ENV+CV lights ON)
INVERTED ATTENUATED: inversely affects the
●
position of the RATE knob, but less
(ENV+CV lights dimmed)
VCA: affects the output amplitude of the channel –
●
the input voltage is proportional to the output amplitude
(behaves as a bipolar VCA, the input and the channel
output get multiplied)
0V = silent output, +5V = normal output, -5V = inverted
output
(LFO light ON)
TRIG: detects the rising edge of trigger signals and then
●
triggers the envelope or resets the LFO.
When ENV is in the SLEW mode, it detects the various
voltages the envelope slews to.
(ENV light ON)
SAMPLE & HOLD: On the rising edge at the input, S&H
●
remembers the current output value of the channel and
holds it until the next rising edge is detected. S&H is only
rendered if a jack is detected at the corresponding input;
otherwise the channel will be unaffected.
(CV light ON)
Advertisement
Table of Contents
