Table of Contents
Advertisement
User calibration
OUTPUT CALIBRATION
The goal of the user calibration is to pair the V/OCT inputs of
your oscillator with one of the Neo Trinity channels. This way
allows the quantizer to achieve a much higher level of precision.
1.
Hold MODE at power-up to enter User calibration mode.
2.
Connect a tuner so it listens to your oscillator. Tune the
oscillator to a root note of your choice in the bass region.
3.
Connect the output of the desired Neo Trinity channel to
the V/OCT input of your oscillator.
4.
Press the corresponding channel button to select the
calibrated channel.
5.
Use the MODE button to cycle between:
0V (CV light ON), 2V (ENV light ON) and 5V (LFO light ON).
6.
Use the CLK (+) and MUTE (-) buttons for fine increments/
decrements of the calibration. Hold the SHIFT button and
press +/- buttons for larger steps.
7.
With every octave tuning point, check your tuner and use
the +/- buttons to tune your Neo Trinity perfectly. Go
through the tuning points several times.
8.
Hold the MODE button for over 5 seconds to leave User
calibration mode. The calibration is stored in the memory.
Advertisement
Table of Contents
