Table of Contents
Advertisement
4 AUTOMATION
There are two components to automation in each of the modes:
RATE AUTOMATION: Hold the REC button and turn
1.
the RATE knob to start recording the automation for the
main parameter. It will influence the channel speed, decay,
or value in the various channel modes.
TRIG AUTOMATION: Hold REC and tap the SHIFT
2.
button to input rhythmic information into the automation
sequencer. It will add resets, envelope triggers, or gates
in the various channel modes.
Once either automation is recorded, the REC light turns ON.
After recording RATE automation, use the RATE knob to offset
the recorded sequence. Park the RATE knob in the middle to
maintain the original recorded automation sequence.
Double tap REC to CLEAR the recorded RATE automation.
Double tap SHIFT to CLEAR the TRIG automation.
While holding MUTE, press and hold REC to ERASE only
specific parts of the automation (erasing while holding both
buttons).
AUTOMATION LENGTH
Hold REC and press channel buttons A/B/C/D/E/F to change
the length of the automation sequence to 2/4/8/16/32/64
steps.
Hold REC and press CLK (+) or MUTE (-) to adjust the length
of the sequence in finer steps.
NOTE: The CLK light blinks shortly at the beginning of the
recorded automation sequence.
Advertisement
Table of Contents
