Table of Contents
Advertisement
●
F – SLEW/AR mode
When the envelope is in the regular triggered mode, it will
only detect triggers on the rising edge of the input and then
it will render the whole envelope shape.
When the SLEW behavior is activated, the envelope will try
to match exactly the input voltage, but slowly, with the
attack and decay settings applied for the rising and falling
times. This is useful for creating sliding sequences, and with
the RATE automation, it can produce very interesting
effects.
NOTE: The IN E/F or META IN has to be set to TRIG mode for
the SLEW to take effect with various voltages.
This specific behavior allows you to use the envelopes as AR
(attack-release) envelopes. Such an envelope will respect the
duration of the input gate. It will render an attack when the
gate goes high and a release when it goes low.
NOTE: With SLEW enabled, when recording trigger automation
by holding REC and pressing and holding SHIFT, the sequencer
records durational gates instead of trigger events.
TRIG/GATE/INPUT:
F
REGULAR TRIG
F
NOTE: In ENV mode, the envelopes are always unipolar and
cannot be switched to bipolar.
SLEW/AR
Advertisement
Table of Contents
