Table of Contents
Advertisement
Connecting and commissioning
5.5 Commissioning and parameter assignment
5.4
Switching on and testing
Procedure for switching on and checking the charging station.
Perform the following steps to switch on the charging station.
1. Switch the power supply on.
Switch on the backup fuses, the load breaker switch and the RCCB.
2. Test run and approval:
Carry out measurements according to the German occupational accident insurance
association (DGUV) regulation 3, or according to the comparable regional regulations.
5.5
Commissioning and parameter assignment
Procedure for setting up the charging station
NOTE
Option: Configuration and communication test
If you have selected the option for customer-specific configuration including SIM card and
communication test to the backend, these settings have already been made at the factory.
NOTE
WebUI
The WebUI is optimized for Mozilla Firefox version 72.0 and higher. Errors in the display may
occur when using a different browser.
NOTE
Operation of the WebUI
• Pressing the "Save" button saves the entry in the charging station.
• Use the "Reload" button to retrieve and display the value from the charging station.
Starting commissioning:
1. System configuration:
A Web interface is available to you for system configuration. To do this, connect a laptop
and the "RJ45 service interface" connection on the Charging controller (Page 24) with a
patch cable.
Check that the network settings of your Ethernet interface on the laptop are set to DHCP.
Open a web browser. Enter the URL specified below in the address line of the browser.
2. Log in with the admin user and the system password.
3. Adjust the parameters according to the specifications of your provider and backend
operator.
50
SICHARGE Operating instructions, ERK
Operating Instructions, 02/2023, A5E48571690-AE
Advertisement
Table of Contents
