Operational Check - Assa Abloy Corbin Russwin IN100 Series Installation Instructions Manual

5

Operational Check

1.
2.
3.
4.
NOTE: Consult premises access control system
for use of RX function and verification of signal.
5.
*Depending upon availability of access control
system either a (denied) red flash or a green
and lock motor cycle (access granted).
For Technical Assistance call Corbin Russwin at 1-800-810-9473
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Insert key into cylinder and rotate.
(Figure 13A)
NOTE: There should be no friction
against lock case, wire harness or any
other obstructions.
Check that key retracts latch.
NOTE: Key should rotate freely.
Throw deadbolt, if present. Check that
key retracts both deadbolt and latch.
Try inside lever; ensure it retracts latch
and deadbolt, if provided.
Present a valid credential* to unlock
outside lever; turn lever handle to
ensure latch retracts. (Figure 13B)
NOTE: Credential should approach
inscription on reader as indicated to
ensure credential is read properly. Do
not wave credential. (Figure 13B)
Fig. 13A
16 FM558 09/23
IN100 Series
FE6600/BL6600/MP6600
Multi-Point Lock
Fig. 13B