Table of Contents
Advertisement
4
Lock Installation (Continued)
6
Install Outside Reader
a. Orient reader so LED lens is at top. (Figure 6A)
b. Feed reader harness through door from outside to inside.
c. Install reader to outside of door by aligning mounting
posts with door preparation holes. Hold reader flush
against door while ensuring proper alignment.
d. Feed reader harness and DPS connectors through inside
mounting assembly and gasket if required*. (Figure 6B)
IMPORTANT:
Do not run wires through bottom flange hole in plate - it
will damage wires and controller connector (Figures 6A-6B)
Route wires around flange, do not route wires through
flange hole. (Figure 6B)
e. Tuck excess cable into wire hole on inside of door.
f. Begin to secure mounting assembly by partially tightening
two (2) through-bolts on inside of door
while ensuring proper alignment as reader is secured.
(Figure 6B)
g. Secure ground lug with #6-32 machine screw.
(Figure 6C)
*NOTE:
•
Gasket is required for outdoor installations
•
Do not use gasket for fire-rated openings
•
If installing with gasket, separate gasket from
mounting plate to feed cables/connectors through
holes as indicated (Figure 6B)
•
Once cables/connectors are fed through, reattach
gasket to mounting plate
For Technical Assistance call Corbin Russwin at 1-800-810-9473
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Fig. 6C
LED
Reader
Assembly
with Harness
NOTE: Cable lengths exaggerated for illustrative purposes
Fig. 6B
12
FM558 09/23
IN100 Series
FE6600/BL6600/MP6600
Multi-Point Lock
Fig. 6A
Gasket*
Inside Mounting
Plate
Through-bolt
Reader
Harness
Through-bolt
Lockbody
Harness
DPS from
Lockbody
Ground Ring
Terminal
Advertisement
Table of Contents
