Table of Contents
Advertisement
4
Lock Installation (Continued)
2
Prepare Lock Body (if necessary)
1. Reverse Lock Hand
Red surface of locking piece must face the out-
side/locked side of door. To rotate locking piece
(Fig. 2B1):
a. Position lock body with red surface of
b. Insert blade type screwdriver into lock-
c. Rotate the locking piece 180° until RED
Note: Red indicates locked side (outside).
2. Reverse Latch Hand
Beveled surface of latch must face strike (Fig. 2B2).
The deadlatch is self adjusting.
To change hand of latchbolt:
Latch will then re-enter lock body.
Note: Latch cannot be unscrewed.
For Technical Assistance call Corbin Russwin at 1-800-810-9473
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
locking piece visible.
ing piece slot to rotate locking piece
toward back of lock body.
surface is on opposite side.
a. Insert screwdriver into spade (triangular)- shaped
slot.
b. Rotate screwdriver 90º to push latch out
until back of latch clears lock front; then
rotate latch 180º.
Locking Guide Slot:
Red color indicates
locked side.
Push In
Fig. 2B1
8
FM558 09/23
IN100 Series
FE6600/BL6600/MP6600
Multi-Point Lock
Right Hand
Lock Shown
Latchbolt
Triangular Slot
Fig. 2B2
Advertisement
Table of Contents
