Advertisement
IN100 Cylindrical Lock
When lock is fully installed, perform the following steps:
a. Insert key into cylinder and rotate (Fig. 14a).
b. There should be no friction against lock case, wire harness or
any other obstructions.
c. Check that the key retracts the latch.
d. The key should rotate freely.
e. Try the inside lever; ensure it retracts latch.
f. Present a valid credential* (Fig. 14b) to unlock outside lever; turn
lever handle to ensure latch retracts.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
6) Operational Check
Note: The credential should approach the inscription
on the reader as indicated (Fig. 13b) to ensure
that the credential is read properly.
Do not wave credential.
16
Advertisement
