Table of Contents
Advertisement
7
Lock LED Indications
Lock has three (3) LEDs. They support an optical scheme with red, yellow and green. Indication scheme described by figures below:
Card + PIN access (configurable)
Access granted, EAC offline or online
Force closed in remote open/office mode
Busy blink, com hub busy w/other locks
*Lock mechanism is blocked when closing
Error in lock, maintenance required
Battery reached end of life, lock disabled
USB cable detection action occurred
Privacy mode** activation (inside)
Privacy mode activation (outside)
Privacy mode deactivation (inside)
*When lock mechanism is blocked (lock jammed) lever must be turned to release lock mechanism.
** Ensure Privacy mode button configuration in lock matches access control system configuration settings.
For Technical Assistance call Corbin Russwin at 1-800-810-9473
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Lock NORMAL OPERATION LED indication
Card access (configurable)
Access denied, EAC online
Access denied, EAC offline
Tamper
Time to replace battery
Some special LED indication schemes are used during lock maintenance actions:
Lock MAINTENANCE OPERATION LED indication
Enter configuration mode
EAC response time
Enter PIN
18
IN100 Series
FE6600/BL6600/MP6600
Multi-Point Lock
One yellow flash after card, two flashes
before PIN (.125 second)
One yellow flash (.25 second)
One green flash (1 sec.)
One red flash (1 sec.)
Five yellow flashes & one red flash (.25 sec.)
Continuous yellow flashes (.25 sec. every sec.)
Three red flashes (.5 second each)
Continuous red flashes (.125 sec. every 1 sec.)
Ten red flashes (.125 sec. each)
(Repeated every 5 sec. if lock can't close)
Ten red flashes (.125 sec. each)
repeated every 5 sec.
Continuous yellow flashes
(.25 sec. every 5 sec.)
Continuous red flashes (.25 sec. every 5 sec.)
Five yellow flashes (.25 second each)
Ten red flashes (.125 sec. each, 1 per sec.)
then one red flash every 3 sec. for 120 sec.
One flash (1 sec.) and 1 beep (if available)
Three red flashes (.125 sec.)
Five yellow flashes (.125 sec. each)
FM558 09/23
Advertisement
Table of Contents
