Table of Contents
Advertisement
4
Lock Installation (Continued)
7
Install Controller Assembly
a. Insert bottom tab of controller -
(ensure path is clear) into slot on mounting plate. (Figure 10A)
b. Ensure proper alignment of board-to-board connectors while pivoting controller
toward door until two tabs on top click
securely into place on mounting plate. (Figure 10B)
CAUTION: To avoid possible damage to board-
to-board connectors, care should be taken when
securing controller to mounting plate. If there is
resistance when securing, detach controller to
determine cause before re-attaching controller.
Fig. 10B
8
Install Batteries
a. Place six (6) "AA" alkaline batteries in compartment, being careful
to align polarity properly. (Figure 11)
b. After batteries are installed, there is a slight delay; then red and
green flash*, audible "beep" and lock motor will cycle.
*See Section 8 - LED Indications for more information.
NOTE: It is recommended to put the batteries on a
replacement schedule of no more than two (2) years.
For Technical Assistance call Corbin Russwin at 1-800-810-9473
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Click
into
place
Fig. 10A
Fig. 11
14
IN100 Series
FE6600/BL6600/MP6600
Multi-Point Lock
Controller
FM558 09/23
(6) AA
Batteries
Advertisement
Table of Contents
