Setting The Pll; Overview; Use Case - Infineon XMC7000 Manual

Clock configuration setup in XMC7000 MCU family
FLL and PLL configuration
4.2

Setting the PLL

4.2.1

Overview

You must configure the PLL before using it.
You can configure these parameters in the System tab of the Device Configurator; based on these,
ModusToolbox™ software automatically generates the corresponding code.
4.2.2

Use case

Parameter
Input clock frequency
Output clock frequency
First, select the source clock for PLL400M#0/PLL400M#1/PLL200M#0/PLL200M#1 in
PATH_MUX1/PATH_MUX2/PATH_MUX3/PATH_MUX4.
Figure 20 Setting 'IMO' in 'Parameters'
Application note
Value
8.000 MHz
350.000 MHz (PLL400 #0)
250 MHz (PLL400 #1)
200.000 MHz (PLL200 #0)
100.000 MHz (PLL200 #1)
20 002-34253 Rev. *C
2023-11-08