Setting The Imo; Setting Ilo0/Ilo1 - Infineon XMC7000 Manual

Clock configuration setup in XMC7000 MCU family
Configuring the clock resources
This code is auto generated after configuration in the Device Configurator.
Figure 16 Code preview
3.3

Setting the IMO

The IMO is enabled by default so that all functions operate properly. The IMO will automatically be disabled
during DeepSleep, Hibernate, and XRES modes. Therefore, it is not required to set IMO explicitly.
3.4

Setting ILO0/ILO1

ILO0 and ILO1 are enabled by default.
Note: ILO0 is used as the operating clock of the watchdog timer (WDT). Therefore, if ILO0 is disabled, you
should disable the WDT. To disable ILO0, write '0b01' to the WDT_LOCK bit of the WDT_CTL
register, and then write '0b00' to the ENABLE bit of the CLK_ILO0_CONFIG register.
Application note 17 002-34253 Rev. *C
2023-11-08