• Remove the pre-installed hardware in the Left Gantry Track to install the Y-Axis Limit Switch Bracket, Front [Y] and Y-Axis Limit Switch Bracket, Rear [Z].
Install the brackets and refasten the hardware (FIG 9).
FIG. 9a
Remove
and refasten
• Verify the Limit Switches will contact and trigger before colliding of
running off the gear rack (FIG 10). If it runs off the track in use, you
may bend the bracket slightly to engage the switch earlier.
• Remove the Torch Height Motor Assembly Mount Bracket (FIG 7) from
the X-Axis Gantry. The Torch Height Motor Assembly with Hardware
installed [K] can now be installed to the Bracket with the pre-installed