Eastwood VERSA-CUT Assembly And Operating Instructions Manual page 14

• The Control Box with Hardware installed [J] can now be installed to the
front right Leg with the pre-installed hardware (FIG 15).
• Plug in the Control Panel Cable [N] to the Cut Controller Box and Con-
trol Box, the Power Cable [O] to the Control Box, Y-Axis Gantry Cable,
Right [P] to the Control Box and right Y-Axis Gantry (FIG 16) and (FIG
8). The Plasma Cutter Control Cable will be connected later.
• Take the Water Trays [A] and butt them up against each other. Gather
the Water Tray Sealing Plates [B], one Water Tray Silicone Seal [C],
and the M6x15 Stainless-Steel Bolts with Washers and Nuts [D]. Only
one Silicone Seal is required, but an extra is included as a spare.
14
FIG. 15
Install
Install
FIG. 16
Plasma Cutter
Control Cable
connector
Power Cable
connector
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
Control Panel
Cable connector
Y-Axis Gantry
Cable connector