Eastwood VERSA-CUT Assembly And Operating Instructions Manual page 9

• If you wish to utilize the included 4" Swivel Locking Casters [DD], now is a good time to install them. Remove the pre-installed hardware and use it to
install them to the Legs via the hole in the foot plate (FIG 2). The table may be used with or without the casters to suit the user's preference.
FIG. 2
• Insert the Gantry Bracing Rods with Hardware installed [V] through the holes at the sides of the frame (FIG 3).
FIG. 3
Gantry Bracing Rods
INJURY HAZARD!
The Eastwood Versa-Cut 4' X 4' CNC Plasma Table has numerous large, unwieldy components that could cause injury or be damaged if they
are dropped. Obtaining the assistance of a capable helper during assembly is strongly recommended.
Components, such as the gear rack teeth, may be sharp. The use of thick, well-fitting work gloves during assembly is strongly recommended.
9
To order parts and supplies: 800.343.9353 >> eastwood.com