Includes - Eastwood VERSA-CUT Assembly And Operating Instructions Manual

INCLUDES

COMPONENTS, HARDWARE/ACCESSORIES; CRATE
(2) Water Tray [A]
(2) Water Tray Sealing Plate [B]
(2) Water Tray Silicone Seals [C]
(20) M6x15 Stainless-Steel Bolts with Washers and Nuts [D]
(14) Water Tray Slats [E]
(1) Leg with Gantry and Control Panel Mount Arm Hardware installed [F]
(3) Legs with Gantry Hardware installed [G]
(1) Cut Controller Box with Hardware installed [H]
(1) Control Box with Hardware installed [J]
(1) Torch Height Motor Assembly with Hardware installed [K]
(1) Y-Axis Gantry Assembly with Hardware installed, Left [L]
(1) Y-Axis Gantry Assembly with Hardware installed, Right [M]
(1) Control Panel Cable [N]
(1) Power Cable [O]
(1) Y-Axis Gantry Cable, Right [P]
A
D
C
W
V
X
4
F
G
B
E
U
(1) Plasma Cutter Control Cable [Q]
(2) Spare Rollers [R]
(1) Allen Key Set [S]
(1) Double Ended Wrench [T]
(4) Lower Table Frame Square Tubes with Hardware installed [U]
(4) Gantry Bracing Rods with Hardware installed [V]
(1) X-Axis Gantry Beam Assembly [W]
(1) Control Panel Mount Arm [X]
(1) Y-Axis Limit Switch Bracket, Front [Y]
(1) Y-Axis Limit Switch Bracket, Rear [Z]
(4) Upper Table Frame Square Tubes with Hardware installed [AA]
(1) Y-Axis Gantry Track, Left [BB]
(1) Y-Axis Gantry Track, Right [CC]
(4) 4" Swivel Locking Casters [DD]
Q
O
N
K
H
M
L
Z
Y
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
R
P
S
T
J
DD
AA
BB
CC