Table of Contents
Advertisement
MAIN CUT SCREEN
• Upon powering up the Plasma Table it will take a few seconds to boot up. Once the Eastwood logo
screen (FIG 28) is displayed, press any key to continue.
• The first screen shown is the Main Cut Screen (FIG 29).
Return to the Main Cut Screen by pressing ESC as many times as necessary.
MAIN CUT SCREEN INTERFACE DESCRIPTION (FIG 29)
[A] Current Torch speed (mm/min).
[B] Current file open.
[C] Counter that shows how many holes (aka pierces) have currently been made and how many there are on the program in total.
[D] Mode specific indicators. Plasma cutting mode shown. Pressing 8 when not cutting will quickly enable/disable the automatic torch height control.
[E] Cut Controller quick reference settings display. Manual speed, cut speed, pierce time, controller mode, kerf, movement mode and steel plate angle.
[F] Torch Height Controller quick reference settings display. Set arc voltage target, IHS set time, THC state, actual arc voltage, and IHS test.
[G] Torch head position with respect to the zero point and THC enable or disable display.
[H] The bottom bar always shows the menu that the function keys will open.
[J] Cut parameters quick access chart. You can input your favorite settings for future reference.
[K] Part preview. The red crosshairs show the zero point and the current torch position. Torch travel will be shown as a red dotted line. The overall part size is
shown on the bottom and right sides of the window.
• G will cycle through the modes: Plasma (FIG 29) and Demo (FIG 30).
• Settings can be quickly changed by pressing their respective quick access key, shown in brackets to the left of the setting. For example, T can be used to
change the pierce time quickly.
• Navigation within setting windows is often done using the arrow keys and the number pad to enter values.
FIG. 29
[A]
[K]
FIG. 30
To order parts and supplies: 800.343.9353 >> eastwood.com
[B]
[J]
[H]
FIG. 28
[C]
[D]
[E]
[F]
[G]
21
Advertisement
Table of Contents
