The EASTWOOD ELITE 8” HEAVY DUTY BEAD ROLLER is a professional metal fabrication tool which proves excellent for producing strengthening ribs in panels used in creating replacement floor pans, firewalls, trunk floors, inner fenders etc. or for adding edge beading to any panel. Also create channels and flanges with the offset flange dies.
PINCH AND CRUSH HAZARD! • The Eastwood Elite 8” Heavy Duty Bead Roller consists of heavy metal components which can present a hand/finger pinch hazard and cause potentially serious injuries if dropped. Avoid pinching hands while handling. The use of safety shoes is strongly recommended.
Page 4
(FIG 3) and tighten vice securely. NOTE: It is helpful to use a vise with a swiveling base, since you will be able to rotate it as needed to maintain a comfortable position while working a panel. Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com...
Roller Dies or deform the Frame. • Tighten the Upper Bearing Block bolt located at the rear of the Bead Roller Frame with a 19mm wrench (not included) (FIG 6). To order parts and supplies: 800.343.9353 >> eastwood.com...
• Do no attempt to start right at a corner or a joint of two lines, since it will be extremely difficult to line up the bead perfectly when you finish. • By using combinations of curves and straight lines, there is almost no limit to the designs you can create with the Eastwood Bead Roller.
Page 7
NOTES To order parts and supplies: 800.343.9353 >> eastwood.com...
Eastwood Elite 27” Bead Roller If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/21487manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.343.9353...