Eastwood VERSA-CUT Assembly And Operating Instructions Manual page 22

F1 - SHAPE LIBRARY
• Pressing F1 on the Main Cut Screen takes you to the shape library (FIG 31). Here preloaded shapes can be selected by using the arrow keys.
• Pressing or F6 on the part opens a screen to modify its dimensions. Lead in and lead out are how far away the Torch starts and stops cutting from the
actual piece being cut. The machine units are configured to millimeters (FIG 32).
• Good lead in/out helps ensure cut smoothness at the entry and exit points. Generally, as much lead in as possible is better up to approximately 15mm or
0.60". Lead out is not as critical and can be much lower.
• After the dimensions have been entered press F7 to open the shape in the main cut screen.
• Some shapes, such as the one shown in (FIG 33), F1 and F2 have the option to switch between inside and outside lead cuts. For example, inside would be
used to cut out a circle. Whereas outside would be used to cut a hole in a panel.
FIG. 31
22
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com