Assa Abloy SARGENT 10X Series Installation Instructions Manual

Installation Instructions
Installation Instructions
10X Line Cylindrical Lockset
1 Tools Required
• #2 Phillips screwdriver • Push pin (provided)
2 Package Contents
10
11
8
9
12
15
16
3 Door Preparation
1. Use template A8290 to mark the door (See Figure 1).
2. Drill the door according to the template.
3. Verify the dimensions (See Figure 2).
4. Install the strike (See Figure 3)
Template
Backset must
match latch
Desired
height
above
DOOR
floor
FRAME
Figure 1
IMPORTANT
• The accuracy of door preparation is critical for proper functioning and security of this lever handle lock. Misalignment can
cause premature wear and a lessening of security.
• Be sure to verify backset before marking and drilling door.
1-800-727-5477 • www.sargentlock.com
Copyright © 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or
in part without the express written permission of SARGENT Manufacturing Company is prohibited.
• 7/16" drill bit
2
7
6
13
3
14
1" (25mm)
hole
2-1/4"
(57mm)
Door bevel
1-1/8"
(29mm)
Figure 2
• 1/8" drill bit
• 5/32" drill bit
4
5
2
7/16" (11mm) hole
2-3/4"
(70 mm)
2-1/8"
(54mm)
hole
5/32" (4mm)
IMPORTANT: Deadlocking latch must stop on
strike when door is closed.
A8286 04/21
• 2-1/8" Bore
Fig.
1 Inside lever handle
2 Rose/Scalp (2)
3 Screws - latch (2) #8-32 x 3/4"
4 Inside spring housing assembly
5 Screws - through-bolt (2) #10-32 x 1-1/4"
6 Lockbody assembly with mounting plate
7 Outside spring housing assembly
8 Cylinder spacer
9 Cylinder
10 Outside lever handle
11 Key
12 Push pin
13 Latch
14 Screws - strike (2) #12-24 x 3/4"
15 Strike
16 Strike box (Optional)
1
Strike Box
Attaching Screws
#12 -24 x 3/4"
Strike
•1" Bore
Description
Strike Box
Attaching Screws
#8 -32 x 3/4"
Figure 3