INFORMATION FOR DISASSEMBLY
7.4.2 Thermostatic valve
1. Undo the screws D and remove the thermostatic
valve cover E.
2. Remove the thermostatic valve F and its gasket.
Important
•
Always replace the gasket G every time it is
disassembled.
3. Check that the air bleeding hole is not clogged or
2.11.3).
blocked
(Par.
7.5 Crankshaft pulley disassembly
NOTE: Perform the operations described in
2 and
3.
1. Undo the screw A (clockwise - as seen from the
timing system side - Ref. A
pulley B.
7.6 Lubrication circuit disassembly
7.6.1 Oil overpressure valve (
1. Undo the cap A.
2. Remove the spring B.
3. Remove the valve piston C using a magnet.
Par. 6.1.5 points
Par.
1.3) and remove the
)
Fig 7.8
Fig 7.9
Fig 7.10
7
79
EN