INFORMATION FOR REPLACING THE
5. Loosen the air bleeding screw F on fuel filter bracket
B.
The air inside the circuit and the filter will begin to
escape from the screw G.
6. Tighten the bleeding screw F (tightening torque of 1.5
Nm) when the fuel begins to flow.
Warning
•
Check that the fuel supply pump filter is present, and
replace if necessary.
1. Release the clamp D.
2. Demount the hose E.
3. Unscrew the filter G from the pump Q.
4. Screw the new filter G onto the pump Q (tightening
torque 20 Nm).
5.
Connect the hose E to the filter G and fasten with the
clamp D.
NOTE: Click on the icon to play the procedure.
FUNCTIONAL UNITS
https://www.youtube.com/embed/mek
o2s8_-U0?rel=0
6
75
EN