Kohler KDI 1903M Workshop Manual page 129

5. Insert tool ST_51 on the injectors junctions Z
(detail X1).
6. Tighten the screw P (tightening torque to 20
Nm).
9.8.2 Fuel injector ricicle pipe
1. Position the tube N on the injectors Z,
and tighten screws M (coppia di serraggio
a 14 Nm) and insert the gasket T.
9.8.3 Rocker arm cover
Important
•
Always replace the gaskets AK after each
disassembly (ST_36
the seats of cap C before assembling the
gaskets)..
1.
Position tool ST_17 onto the head in
correspondence with the two fastening holes
5 and 6 (Fig. 9.66 - 9.67).
2.
Position the gasket AM on the head AL using
tool ST_17 as a guide.
3.
Fit the rocker arm cap C on the head AL via
the screws L observing the clamping
sequence illustrated in Fig. 9.66 (KDI 1903
M) or Fig. 9.67 (KDI 2504 M) (tightening
torque at 10 Nm).
4. With vaseline lubricate the gaskets AK.
Fig 9.66
ASSEMBLY INFORMATION
Fig 9.63
Fig 9.64
- apply Loctite 480 to
Fig. 9.67
Fig 9.65
9
129
EN