Section 8. Disassembly/Reassembly; Disassembly - Kohler 10CCOZ61 Service Manual

Section 8. Disassembly/Reassembly

Prior to disassembly, the generator set must be unbolted
from the vehicle compartment. Disconnect all external
devices--battery cables at the battery (negative lead
first), AC output loads at the controller, fuel line at the
fuel pump filter inlet, and the exhaust connections.
Observe all safety precautions listed at the beginning of
this manual during
procedure.
NOTE
The procedure for disassembly/reassembly may vary
due to product updates and assembly variations. Major
differences are noted where appropriate.
NOTE
The voltage regulator is located in the controller chassis.
Adjustments are possible without removing the
controller or chassis.
NOTE
HARDWARE DAMAGE! Engine and generator may
make use of both American Standard and metric
hardware. Be sure to use the correct size tools to
prevent rounding of bolt heads and nuts.

Disassembly

1. Remove the nine screws securing the controller
cover. Separate the cover from the controller. See
Figure 8-1.
TP-5648 8/93
the disassembly/reassembly
3
1. Cover
2. Screw
3. Controller
Figure 8-1. Removing the Controller Cover
1
2
Disassembly/Reassembly 8-1