INFORMATION FOR REPLACING THE
8. Fit the timing system crankcase C with the
screws R observing the indicated clamping
sequence (tightening torque at 25 Nm).
6.4.7 Crankshaft pulley assembly
1. Perform the operations described in
6.4.8 Coolant pump assembly
1. Perform the operations described in
6.5 Oil pressure valve replacement
6.5.1 Disassembly
Important
•
Before proceeding with operation, read
1. Undo the cap A.
2. From the crankcase D, remove the spring B.
3. Remove the valve piston C using a magnet.
6.5.2 Assembly
Important
•
Carry out the checks described in
assembly.
•
Always replace the gasket F after each assembly.
1. Lubricate the piston C and fully insert it in the seat
E.
2. Insert the spring B in the piston.
3. Mount the gasket F on cap A.
4. Clamp the cap A on the crankcase D (tightening
torque at 50 Nm).
FUNCTIONAL UNITS
Par
6.3.2.
Par
6.2.2.
Par.
3.3.2.
Par. 8.7.3
prior to
Fig 6.45
Fig 6.46
Fig 6.47
6
73
EN