6
6.6 Oil filter replacement
6.6.1 Disassembly
Important
•
Before proceeding with operation, read
•
Perform the operations described in
1. Unscrew the cartridge A.
6.6.2 Assembly
Important
• In the event of mounting the fitting U on the crankcase S
(tightening torque at 1 5 Nm + Loctite 2701).
1. Check that the surface Q on crankcase S are free
from impurities.
2. Screw the cartridge A on the fitting U (tightening
torque at 15 Nm).
6.7 Fuel filter replacement
Important
•
Before proceeding with operation, read
Warning
•
In case of low use replace il 12 months.
1. Procure a suitable container to collect the fuel.
2. Rotate the filter A to take it to the unlocked position
and remove it.
3. Lubricate the gasket C.
Assemble the filter A on the support B and rotate it
until reaches the lock position.
Important
•
Do not fill the new cartridge A with fuel.
4. Turn the key on the control panel to the ON position.
The electric pump D sends fuel to the filter and then
the injection pump E.
EN
74
INFORMATION FOR REPLACING THE
FUNCTIONAL UNITS
Par.
Par.
3.3.2.
5.2.
Fig 6.48
Fig 6.49
Par. 3.3.2
Fig 6.50
Fig 6.51