Kohler KDI 1903M Workshop Manual page 153

INFORMATION ABOUT OPTIONAL
2. Remove the centring ring C and the relative
gaskets
3. Undo the screws N.
4. Remove the flange F with the components D, E,
G and H in the direction of the arrow P.
5. Remove the gasket J.
6. Remove the retainer ring D and the shoulder
washer E.
7. Remove the gear H and the shoulder ring G
from the flange F in the direction of the arrow Q.
11.6.2 Assembly
Important
•
Always replace the gasket J after each
assembly.
•
Lubricate the gear H with oil.
•
It is mandatory to replace the screws N or apply
a few beads of Loctite 2701.
1. Insert the gear H in the flange F in the direction
of the arrow R inserting the shoulder ring G.
2. Insert the shoulder ring E on the flange F and
clamp the gear H using the retainer ring D.
COMPONENTS
Fig 11.14
Fig 11.15
Fig 11.16
Fig 11.17
11
153
EN