11.2.2 Assembly
Important
•
Always replace gaskets F, with each assembly.
1. In sequence, fit the manifold G with the gasket F, the
new heater E, the second gasket F, the flange C, the
washers H, the screws A and the cable B.
2. Secure the flange H with the screws A (tightening
torque at 22 Nm).
3. Secure the earth cable B with the nut J and the
relevant washer on the heater E.
11.3 Poly-V alternator belt (replacement and adjustment)
Important
•
Before proceeding with operation, read
1. Loosen the nut B and manually tighten the screw C
until it just touches the pulley pin D (Fig. 11.9).
2. Untighten the screw E by around 32mm (A).
3. Untighten the screw C.
NOTE: The belt tensioner pulley F should move towards the
arrow G. If it does not, please move it manually.
INFORMATION ABOUT OPTIONAL
COMPONENTS
Par.
Fig 11.7
3.3.2.
Fig 11.8
11
147
EN