Attach Slide Rail To Rack; Attach Chassis To Slide Rail - Magma EB4-1U User Manual

Attach Slide Rail to Rack

Attach to inside of rack with "fingers" pointing "out" and the end bracket
to the rear. Secure each Slide Mount with 4 screws as shown below.
Secure the slide rail to the
rack with 2 screws to both
front and rear posts. After
you have secured the slide
rail fingers to the rack posts,
tighten the 2 screws used to
attach the slide rail to the end
bracket.

Attach Chassis to Slide Rail

Next, insert the chassis into the rack slide and press it forward until the
chassis stops. When the chassis is completely inserted into the rack,
fold the hinged mounting brackets back against the rack post and
secure with 2 screws on each side.
The chassis mounts into the rack
from the rear. Before you can
attempt to insert the chassis's rack
slide into the half of the rack slide
you just mounted to the rack, you
must first fold the hinged mounting
brackets to a forward position as
shown.
Chapter 2 Hardware Installation
M A G M A
7