Change User Name And Password - Magma EB4-1U User Manual

M A G M A
Change the Trap Destination IP Address to the IP address of the
computer getting the SNMP data. The default Trap Destination IP
address is 10.203.11.15.
Change the Alarm Settings for both the Front and Rear Alarm settings
by entering both a high and low temperature in the appropriate fields.
Any time the temperature in the chassis goes above or below these
limits, an audible alarm will sound a nd an Alarm Light will light. The light
above the Alarm Reset Button will
light whenever the temperatu re in
the front of the chassis exceed s
your temperature limits. The
bottom light will light whenever the
temperature in the rear of the
chassis exceeds your temperature
limits. Remember to push the
Alarm Reset Button to reset and
silence the audible alarm.
When you h ave finished configuring the SNMP settings, you can either
configure the network settings as described in the previous section,
change the default user name and password as described below, or
save the current changes by clicking on the Submit New Settings
button at the bottom of the screen.

Change User Name and Password

This section allows you to change t he default user name (default) and
password (magma). To change the user name, simply enter your new
user name in the user name field. To change your password, enter your
new password in the password field. Enter it again in the
password(again) field. The password in both fields must match before
they can be accepted.
22 Chapter 4 Install Cards and Drives