Product Usage/Use Instructions - Tesla LASER AI300 PLUS User Manual

Product usage/use instruction
Power On/Off
Press and hold key to power on the robot, power indicator lights on and robot
enters into standby mode. When the robot is in quiet state, press and hold
to power off the robot, then the cleaning ends.
! Notes: The robot cannot power off while charging.
Start Cleaning
Press key to start cleaning, the robot dynamically plans the cleaning path
according to the map generated by scanning, and completes cleaning of different
zones one by one. In each zone, the robot starts edge cleaning first and then does
the remaining part by zigzag cleaning.
Zone 1: Cleaned Zone2: Cleaned
Zone 4: to be cleaned Zone 3: cleaning
Notes:
The robot cannot start cleaning if the battery is too low. Please start cleaning after
key
charging.
Please tidy up all kinds of cables (including power cable of charging base) on the
ground before cleaning, otherwise the robot may drag the cables and lead to the
power off of other home appliances or damage of items or cables.
If the cleaning zone is less than 4 square meters, the robot will clean twice by de-
fault.
Resumable cleaning: If the battery is insufficient during cleaning, the robot will go
back to the charging base for recharging and automatically resume to interrupted
place to continue cleaning after being fully charged. (This function can be opened
or closed on the APP).
Pause
While working, you can press
water or to clean the mop. Press
back to the charging station and end the cleaning.
! Notes: If the robot is put back to the charging station in the pause state, the clea-
ning will end.
Sleep Mode
If no operation is performed after 10 minutes, the robot automatically enters the
sleep mode, and the power indicator goes off. In the sleep mode, you can press any
button to wake the robot up.
11
to pause the robot if the water tank needs more
key to continue cleaning, or press
EN
key to