D-Link DGS-1210 Series Manual page 112

4 Web-based Switch Configuration
Assign sequence number:
Sequence No. (1-65535): Specifies the sequence number. The value is from 1 to 65535.
Auto Assign: Auto assign the sequence number for a new rule.
Assign Rule Criteria: Specifies the MAC address settings.
Source: Select the source MAC to be specified or Any. Enter a source MAC address and source MAC mask,
e.g. FF-FF-FF-FF-FF-FF.
Destination: Select the destination MAC to be specified or Any. Enter a destination MAC address and
destination MAC mask, e.g. FF-FF-FF-FF-FF-FF.
If user selects the 802.1Q VLAN box, then need to specify the dot1p and VLAN ID.
Dot1p (0-7): Specifies the dot1p priority.
VLAN ID: Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
If user selects the Ethernet Type box, then need to specity the Ethernet Type and select the Action.
Ethernet Type: Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
Action: Specifies the ACL forwarding action matching the rule criteria. Permit forwards packets if all other
ACL criteria are met. Deny drops packets if all other ACL criteria is met.
Priority (0-7): Specifies the MAC ACL priority whish values are 0-7.
Replace Priority: Check the box to enable the Replace Priority feature.
Click Next button then the ACL profile is added.
Figure 4.134 – Add Access Rule - MAC
1 0 5
1 0 5
D-Link Smart Managed Switch User Manual