D-Link DGS-1210 Series Manual page 127

4 Web-based Switch Configuration
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. user can select From Port / To Port to control the PoE functions of
a port. The DGS-1210 series will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
From Port / To Port: Specifies the PoE function of a port or ports.
State: Select "Enabled" or "Disabled" to configure PoE function for designated port(s). Default is Enabled.
Time Range: Select the PoE time profile configured from Time-Based PoE > Time Range Settings to enable
the time-based PoE function on designated port(s). Default setting is N/A.
Priority: Configure the power supply priority as "Low", "Normal", or "High" on designated port(s). Default is
Normal.
Delay Power Detect: Configure the delay power detection. Default is Disabled.
0 Default
1 Optional
2 Optional
3 Optional
4 Optional
Note: The PoE Status information of Power
current, Power Voltage, and Current is the power
usage information of the connected PD; please
"Refresh" to renew the information.
Figure 4.152 – PoE > PoE Port Setting
120
D-Link Smart Managed Switch User Manual
15.4W
4.0W
7.0W
15.4W
30W