D-Link DGS-1210 Series Manual page 146

5 Surveillance Mode Configuration
Parameter
Get IP From
IP Address
Mask
Gateway
Click the Apply button to implement changes made.
The fields that can be configured for the SNMP Host Settings are described below:
Parameter
Community Name/SNMPv3
User Name
Host Ipv4 Address
Click the Apply button to implement changes made.
The fields that can be configured for the Log Server are described below:
Parameter
Host IPv4 Address
Host Ipv4 Address
Click the Apply button to implement changes made.
The fields that can be configured for the Password Settings are described below:
Parameter
Old Password
New Password
Confirm Password
Click the Apply button to implement changes made.
The fields that can be configured for the Uplink Port Settings are described below:
Parameter
From Port
To Port
Click the Add button to implement changes made.
Click the Delete button to delete any entries in the list of uplink ports.
Description
Specifies how the management IP for this VLAN is assigned to the
switch. Options are: Static, DHCP or BOOTP. If Static is chosen, the
following fields become available.
Specifies the IP address for the surveillance VLAN management IP.
Specifies the netmask for the surveillance VLAN management IP.
Specifies the gateway for the surveillance VLAN.
Description
Specifies the community name or SNMPv3 user name to be
configured.
Specifies the IPv4 address of the SNP Network Management Server
(NMS) which will receive SNMP Traps from this device.
Description
Specifies the IPv4 address of the Syslog NMS which will receive
Syslog messages from this device.
Specifies the IPv6 address of the Syslog NMS which will receive
Syslog messages from this device.
Description
Enter the old password that is used to restrict access to the device via
the Web UI. Password length is a maximum of 20 characters.
Configure a new password that will be used to restrict access to the
device via the Web UI. Password length is a maximum of 20
characters.
Confirm the password that will be used to restrict access to the device
via the Web UI. Password length is a maximum of 20 characters.
Description
Specifies the start port in the range for Uplink Ports. These are used
for connecting the surveillance VLAN with other switches.
Specifies the end port in the range for Uplink Ports. These are used for
connecting the surveillance VLAN with other switches.
1 3 9
1 3 9
D-Link Smart Managed Switch User Manual