Table of Contents
Advertisement
INSTALLATION
Step
Step
6
- Route the electrical supply cable into the
shower unit.
Note: The supply cable must be secured either
by routing through conduit, trunking or by
embedding in the wall, in accordance with IEE
regulations.
- Insert the conductors into the appropriate
position on the terminal block.
Note: The earth conductor must be sleeved. The
outer sheath of any conductor must be stripped
back to a minimum.
- Fully tighten the terminal block screws and
make sure that no cable insulation is trapped
under the screws.
IMPORTANT: Loose connections can result in
cable overheating.
DO NOT switch on the electricity supply.
Step
Step
7
Refit the splashguard and secure with
the 2 fixing screws.
Earth cable (Green/Yellow) to
Neutral cable (Blue or Black) to
Live cable (Brown or Red) to
Terminal block
For trunking installations - position
cover to the product. Mark out the
width and depth of the trunking on the
cover. Make cuts to the cover keeping
a tight fit.
16
N
L
E
L
N
Step
Step
8
Advertisement
Table of Contents
