Installation - Triton OMNICARE ULTRA CINCULT09W Manual

INSTALLATION

POSITIONING THE SHOWER
For ease of servicing, the unit must always be mounted on the surface of tiled walls.
Never tile up to the unit.
Position the unit where it will not be in direct contact with water from the shower head.
Mount the shower unit vertically.
Allow enough room between the ceiling and the shower to access the top cover screws.
Using the backplate as a template, mark out the entry points and routing of the water and electric
supplies into the shower.
Find our step-by-step installation video for this product on our YouTube
channel. Go to youtube.com/TritonShowers and search for 'how to guides'.
Step Step
1
Remove the front cover assembly, the 2
screws securing the splashguard and the
splashguard.
Step Step
- Complete all the plumbing pipework.
3
- Ensure that any soldering of pipework is done away from the shower as
heat can travel along pipework and damage components.
IMPORTANT: Before connecting the shower to the plumbing pipework,
flush out the pipework for approximately 60 seconds to remove any
swarf or debris.
Step Step
2
Top Entry
Bottom Entry
Rotate inlet fitting to suit the required
water supply pipe entry position.*
*Take care not to trap or tangle earth wire on the inlet fitting
14
Rear Entry
