Baroness LM18GC Owner's Operating Manual page 79

Adjustment of Engine Clutch
Adjust the clearance between the engine
clutch and clutch facing so that it will be 0.5
- 1.0 mm (0.020 - 0.039 in) when the main
clutch lever set to the "ON" position.
A
1
Adjustment of Engine Clutch_001
1 Engine clutch
2 Clutch facing
A 0.5 - 1.0 mm (0.020 - 0.039 in)
1. Loosen the four bolts A securing the
engine.
Be sure not to loosen the bolts B.
2. Insert a thickness gauge (accessory tool)
between the engine clutch and the clutch
facing.
Make adjustment of the engine position
so that the front and rear clearances will
be the same distance, and then tighten
the bolts A.
2
Adjustment of Engine Clutch_002
1 Engine
2 Bolt A
3 Bolt B
Adjustment and Replacement
2
wdzf6u-001
1
3
wdzf6u-006
LM18GC・LM56GC / LM66TC
Adjustment of Clutch Wire
Important
Make sure that the wire is not cracked or
damaged.
If the wire is cracked or damaged, replace it
with a new one immediately.
Important
Due to frequent use, movement of the lever
will become dull, play of the inner wire will
change and the inner wire will be stretched
depending on R angle of the outer wire.
Inspect them and, if necessary, implement
adjustment.
Make adjustment of the clutch wire so that
the operation distance of the clutch plate
between "ON" and "OFF" positions of the
main clutch lever will be 1.0 - 2.0 mm
(0.039 - 0.079 in).
1. Loosen the clutch wire adjusting nuts.
2. Adjust the operation distance of the
clutch plate by changing the clutch wire
position.
3. After appropriate adjustment of the
operation distance of the clutch plate
completed, tighten the clutch wire
adjusting nuts.
1
Adjustment of Clutch Wire_001
1 Engine clutch
2 Clutch plate
3 Clutch facing
4 Clutch wire adjusting nut
5 Clutch wire
A 1.0 - 2.0 mm (0.039 - 0.079 in)
Repair
5
4
3
2
A
wdzf6u-007
Page 7-3