Baroness LM18GC Owner's Operating Manual page 59

A
A
Cutting Height and Blade Thickness of Bed Knife (Bottom
1 Standard blade
2 High-speed-steel-tipped blade
A Thickness of blade
Adjustment of Front Roller
You can adjust the cutting height by moving
the front roller up or down.
The cutting height can be adjusted to the
maximum of 29.0 mm (1.141 in).
3
1
A
2
Adjustment of Front Roller_001
1 Front roller
2 Front groomer
3 Reel cutter (Cutting cylinder)
4 Drum
5 Bed knife (bottom blade)
A Cutting height
1. Set the slide caliper to the required cutting
height, adjust the position of the bottom of
the head of the small screw for cutting
height setup in the cutting height gauge,
and then securely lock it with a fly nut.
Adjustment and Replacement
1
2
33i8xn-002
Blade)_001
4
5
3kws2a-012
LM18GC・LM56GC / LM66TC
Maintenance
2. Loosen the nut securing the roller adjuster.
1
2
Adjustment of Front Roller_002
1 Roller adjuster
2 Nut
3. Position the cutting height gauge against
the front roller and drum at the edge on the
left and right sides of the mower unit.
4. Move the front roller up or down with the
roller adjuster to position the front roller so
that there is no gap between the bottom of
the head of the small screw for cutting
height setup in the cutting height gauge and
the edge of the bed knife (bottom blade).
1 2
3
A
9
8
6
Adjustment of Front Roller_003
1 Front roller
2 Roller bracket
3 Front groomer
4 Reel cutter (Cutting cylinder)
5 Drum
6 Bed knife (bottom blade)
7 Cutting height gauge
8 Small screw for cutting height setup
9 Small screw for groomer setup
A Cutting height
5. Follow the same steps to adjust the cutting
height on the opposite side.
6. Tighten the nuts that secure the left and
right roller brackets to secure them firmly.
3kws2a-014
4
5
7
3kws2a-015
Page 6-9