Baroness LM18GC Owner's Operating Manual page 69

1 Cutter pin
2 Lock nut
3 Cam bush
2. Remove the 2 bolts that secure the bed
knife base arm Assy and bed knife base
COMP.
2
Removing The Bed Knife Base_002
1 Bed knife base COMP
2 Bolt
Important
Keep 1 to 5 pieces of washer for clearance
adjustment between the fulcrum seat and the
frame if there are any of them.
3. Unscrew the fulcrum seat bolt, S washer,
washer, and remove the bed knife base
arm Assy from the bed knife base COMP.
2
3
4
1
Removing The Bed Knife Base_003
1 Bed knife base arm Assy
2 Bolt
3 S washer
4 Washer
Caution
Be careful when you remove the cutter pin as
the bed knife base COMP may fall off.
Adjustment and Replacement
1
2
5ttm1g-002
Installing The Bed Knife Base
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
When handling the reel cutter (cutting
cylinder) or bed knife (bottom blade), wear
gloves to protect your hands.
Pay attention not to let the reel cutter (cutting
cylinder) catch your gloves. Otherwise, you
may injure your hand or fingers.
While operations are performed with the front
of the machine raised, it may fall.
Securely support the machine.
5ttm1g-003
Important
Make sure that there is no binding at the cam
bushes in the frame of the mower unit.
LM18GC・LM56GC / LM66TC
Maintenance
4. While supporting the bed knife base COMP,
remove the cutter pins and lock nuts on
both sides.
5. Remove the bed knife base COMP.
Removing The Bed Knife Base_004
1 Bed knife base COMP
Caution
Caution
Caution
1. Remove the right and left cam bushes.
2. Clean the cam bushes and the cam bush
mounting portions on the frame and grease
them.
3. Install the cam bushes.
1
5ttm1g-004
Page 6-19