Baroness LM18GC Owner's Operating Manual page 67

Note:
The outer diameter of the reel cutter (cutting
cylinder) shaft is 25.4 mm (1.00 in).
3
B
Replacement of Reel Cutter (Cutting Cylinder)_001
1 Reel cutter (cutting cylinder) blade
2 Reel cutter (cutting cylinder) disc
3 Reel cutter (cutting cylinder) shaft
Outer diameter of reel cutter (cutting
A
cylinder)
Distance from blade edge to outer
B edge of reel cutter (cutting cylinder)
shaft
Installing The Reel Cutter (Cutting Cylinder)
Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
When handling the reel cutter (cutting
cylinder) or bed knife (bottom blade), wear
gloves to protect your hands.
Pay attention not to let the reel cutter (cutting
cylinder) catch your gloves. Otherwise, you
may injure your hand or fingers.
Follow the steps below to replace the
bearings and oil seals on the left and right
ends of the reel cutter (cutting cylinder).
Adjustment and Replacement
2
1
A
ok5ueg-006
LM18GC・LM56GC / LM66TC
Important
Use 30204JRP6 as bearing.
1. Fill up the bearings and oil seals with
grease (Excelite EP No. 2).
2. Install the reel cutter (cutting cylinder) onto
the frame.
3. Tighten the nut until the length of the spring
reaches 11.5 mm (0.453 in), and then lock
it.
Note:
Preloading with a constant force by spring
pressure is possible.
4. Measure the rotating torque of the reel
cutter (cutting cylinder) with a torque
wrench.
The specified value is 0.8 to 1.0 N·m (8 to
10 kgf·cm).
Specification without groomer:
3
Installing The Reel Cutter (Cutting Cylinder)_001
1 Washer
2 Left-hand nut
3 Torque wrench
A 11.5 mm (0.453 in)
Specification with groomer:
3
Installing The Reel Cutter (Cutting Cylinder)_002
Maintenance
A
1 2
wggg9e-013
A
2
1
wggg9e-014
Page 6-17