Baroness LM18GC Owner's Operating Manual page 56

LM18GC・LM56GC / LM66TC
Maintenance
Important
Adjust the right and left link rods so that they
will be as long as each other.
1. Remove the snap pin and washer and then
remove the flat head pin.
2. Loosen the nut A and turn the L-shape
bracket to adjust the length of the link rod.
When raising the handle, shorten the link
rod.
When lowering the handle, lengthen the link
rod.
3. Attach the flat head pin, washer and snap
pin to the forefront of slotted hole of the L-
shape bracket.
4. Make sure that the handle pipe locates at the
center of the handle guide.
5. Tighten the nut A.
5
2,3
4
6
Adjustment of IGCA (Independent Grass Catcher Arm)_002
1
2
3
4
5
6
7
6. Repeat the same process for adjustment of
the opposite link rod.
Adjustment of gap for the grass catcher:
Important
Adjust so that the grass catcher will not
overlap with the stay.
Important
Adjust so that the small gap between the
grass catcher and the stay will be even.
Page 6-6
1
7
gp7sf7-002
Link rod
Snap pin
Washer
Flat head pin
L-shape bracket
Nut A
Nut B
2
Adjustment of IGCA (Independent Grass Catcher Arm)_003
1 Grass catcher
2 Stay
A Gap
1. Loosen the right and left locknuts.
2. Remove the right and left clip pin.
Important
The shaft has a through-hole into which the
clip pin will be inserted.
To adjust length always turn the shaft 180
degrees to keep holes aligned.
3. Turn the right and left shafts to adjust so that
the gap between the grass catcher and the
stay will be 1.0 mm (0.039 in).
4. Tighten the right and left locknuts.
Adjustment of IGCA (Independent Grass Catcher Arm)_004
1 Locknut
2 Clip pin
3 Shaft
Adjustment and Replacement
A
1
gp7sf7-003
2
3
1
gp7sf7-004