Baroness LM18GC Owner's Operating Manual page 70

LM18GC・LM56GC / LM66TC
Maintenance
4. Temporarily install the bed knife base
COMP onto the machine with the left and
right cutter pins and lock nuts.
Note:
At this time, tighten the lock nuts to the
heads of the cutter pins, but do not allow
the lock nuts to contact the cam bushes.
4
3
2
Installing The Bed Knife Base_001
1
2
3
4
Important
Install the bed knife base arm Assy parallel to
the frame.
During installation, be careful not to twist both
arms.
5. Insert the bed knife base arm Assy into the
bed knife base COMP.
6. Temporarily install the bed knife base arm
with the bolt of the fulcrum seat.
2
3
4
Installing The Bed Knife Base_002
1
2
3
4
Page 6-20
1
kx7caa-001
Bed knife base COMP
Cutter pin
Lock nut
Cam bush
1
kx7caa-002
Bed knife base arm Assy
Bolt
Spring washer
Washer
7. Tighten the bolt used to install the bed knife
base arm Assy, and then firmly secure it.
3
2
1
Installing The Bed Knife Base_003
1 Bolt
2 Spring washer
3 Washer
Important
Do not tighten the left and right lock nuts.
8. Tighten the left and right cutter pins used to
temporarily install the bed knife base
COMP.
9. Remove the fulcrum seat bolt used to
temporarily install the bed knife base arm.
Note:
With the weight of the bed knife base arm,
the bed knife (bottom blade) will slightly
come into contact with the reel cutter
(cutting cylinder).
10. Align the punch mark on each (left and
right) cam bush with the travel direction.
Installing The Bed Knife Base_004
1 Punch mark
Adjustment and Replacement
kx7caa-003
1
kx7caa-004