Roland GP-100 Owner's Manual page 29

Assign Hold
=519ғ Hold
Specifies whether or not the previous values of controller sources
will be maintained when the Patch changes.
On: Controller source values will be maintained when the
Patch changes. When you select a new Patch number,
target parameters which are using the same sources will
maintain the previous values of the controller sources.
Off: — Controller source values will not be maintained when the
Patch changes. When you select a new Patch number, the
effect sound will initially be unaffected by the current
position of the controllers. As soon as you move a control-
ler and its data is transmitted to the GP-100, the target
parameter for that controller will be affected.
LCD Contrast: 1—15
Depending on the location where you place the GP-100, the
display may be difficult to read. In this case, adjust the display
contrast.
«MIDI-Related Settings»
This section contains the MIDI-related settings. The following
parameters can be set. For details on each parameter, refer to
"MIDI Utility function settings" (p. 53).
MIDI Channel: 1—16
MIDI Omni Mode: On, Off
MIDI OUT/THRU: Out, Thru
MIDI Bulk Dump
MIDI Bulk Load
MIDI MCR-8 Edit: On, Off
MIDI MCR-8 CH (MCR-8 MIDI channel): 1—16
MIDI Map Select: Prog, Fix
MIDI Program Map
Section 2 Modifying various settings
«Harmonist Settings»
This setting determines the harmony that is used when the
Harmonist function is set to "Mode:Harmony" and "Scale:User."
If setting the scale to "Preset" (preset scale) does not produce the
harmony you want, make scale settings here (User Scale) to create
the harmony you specify.
To make settings, use the PARAMETER knob to specify the
harmony and the input note, and use the VALUE knob to specify
the pitch shift amount (-24—424) of the harmony. For details, refer
to "Harmonist: About the User Scale" (p. 65).
<FC-200 Settings>
You can make FC-200 settings from the GP-100. The settings you
make are transmitted via MIDI to the FC-200. The following
parameters can be set. For details on connections etc., refer toto
"GP-100 Operation Using the FC-200"(p. 58).
FC200 CTL Pedal (contro! pedal): Momentary, Latch
FC200 Bank Limit: 0—39
FC200 Program Change Out: On, Off
FC200 Bank Change: Bank Pedal Only, Use Number Pedal
FC200 Jack Loop: PC-CC-PC
PC-CC-NT-PC
PC-CC-EX-CC
PC-CC-NT-EX-PC
29