Roland GP-100 Owner's Manual page 42

Section 3 Effect Gulde
The timing at which you press the foot switch and the Interval
setting together determine the delay timing as follows.
5 14 Bhp eth ct ht th 9 A a td dp
his
bh 4444424424
FB. 38 A 42444244
P12
> 4 4 à 253935
js 273 d 4 <) | 4) 4 4) |
howd A 4 4) | 4) | 4) 4
J) ue 4 P 3 4 4
jd X à | <) | à
оза
J 4
|
à
|
By setting one of the assignable controllers "Assign 2"—
"Assign 16" to the following settings, you can use a foot switch
to input tempo.
Target DD:Tempo In
(Target Min Off)
(Target Max On)
Source
«when using CONTROL 1 or CONTROL 2»
CONTROL 1 or CONTROL 2
«When using the CTL pedal of the FC-200>
MIDI CTL 480
Source Mode Normal
(Source Act.Range lo 0)
(Source Act.Range Hi 127)
Using the CONTROL Jack
if you wish to connect an FS-5U foot switch (optional: BOSS)
to this jack for tempo input, make the following settings. For
details refer to "CONTROL 1/2 Jack" (p. 28).
«UTILITY»
CONTROL 1 Jack: Assignable
or
CONTROL 2 Jack: Assignable
42
Using the FC-200
When the FC-200 is in its initialized state, it can be used with
the above settings.
* if you have changed the controller number of the CTL pedal, set
the control assign "Source" to match the number you set.
the interval setting.
Equalizer
Adjusts the tone. Parametric control is provided for the high-mid
range, mid range, and low-mid range.
Low EQ
Adjusts the low frequency range tone.
Low-Middle frequency
Specify the center of the frequency range that will be adjusted by
the "Low-Middle EQ."
Low-Middle Q
Adjusts the width of the area affected by the EQ centered at the
"Low-Middle Frequency." Higher values will narrow the area.
Low-Middle EQ
Adjusts the low-middle frequency range tone.
Middle frequency
Specify the center of the frequency range that will be adjusted by
the "Middle EQ."
Middle EQ
Adjusts the middle frequency range tone.
High-Middle frequency
Specify the center of the frequency range that will be adjusted by
the "High-Middle EQ."
High-Middle ©
Adjusts the width of the area affected by the EQ centered at the
"High-Middle Frequency." Higher values will narrow the area.
High-Middle EQ
Adjusts the high-middle frequency range tone.
High EQ
Adjusts the high frequency range tone.
Level
Adjusts the volume after the equalizer.