Power-On And Standby; Adjusting The Input Семе; Adjusting The Output Level (Headphone Level); Setting The Nominal Input/Output Level - Roland GP-100 Owner's Manual

Power-on and Standb
Power-on
After checking the connections with external devices, press the
GP-100's power switch to turn on the power.
The following display will appear, and after several seconds, the
GP-100 will be ready for normal playing. This display is referred
to as the "Play page."
Car*- 16969
Roland Corr,
<Play page>
(OM
--BASIC--
Sample Setting
* Turn up the amp volume only after all devices have been powered-on.
* When the power is turned on, the last-selected Patch number will be
selected.
* The GP-100 contains a protection circuit that inserts a short delay after
power-on until operation begins.
* Depending on the location where the GP-100 is placed, the display may
be difficult to read. In this case, adjust the display contrast (p. 29).
Adjusting the INPUT Level
The level of the output signal differs between guitars. Use the
INPUT Level knob to adjust the input level to suit your guitar.
1 Play your guitar at the maximum loudness that you will
produce in normal playing.
The SIGNAL Indicator will light in response to the input sound.
2 Adjust the INPUT Level knob until the CLIP Indicator lights
briefly.
* The clip indicator will light 6 dB before clipping level (the level where
distortion begins).
* If the input level is too high, the GP-100 will not produce the desired
effects.
Adjusting the Output Level
(Headphone Level)
Use the OUTPUT Level knob to adjust the output level of the GP-
100. Make adjustments as appropriate for the devices that are
connected. Adjusting the OUTPUT Level knob will also change
the headphone level.
Section 1 Try out ihe GP-100
Setting the Nominal Input/Output
Level
Adjust the nominal input/output level of each INPUT/OUTPUT
jack as appropriate for the external equipment that is connected.
(Procedure)
1 2 3
| NUMBER,
PARAMETER — VALUE
eines fae жы ES О
C
ee
5
1 Press [UTILITY] once to get the following display.
OUTPUT Jack A
OUTPUT A Level
TddEn
2 Rotate the PARAMETER knob until the parameter you wish to
modify appears in the display.
OUTPUT Jack A
OUTPUT A Level
+4 Br
OUTPUT Jack B
OUTPUT B Level
+44Е
SEND Jack 1
SEH 1 Lewel
-lüdEm
RETURN Jack 1
RETURH 1 Level
-lüdBm
SEND Jack 2
SEHD 2 Level
-l8dEm
RETURN Jack 2
RETURN 2 Level
-184Ем