Roland GP-100 Owner's Manual page 22

Section 2 Modifying various settings
Amount of Change in
Controller Parameter Value
ON 100%
Max.
Value
Min.
Value
OFF 096
Amount of Change in
Controller Parameter Value
Мах. 100%
Value Max.
Value
Min
Value
Min.
Value 096
Controller Parameter Value
Max. ON
Value
Median
Value
Min.
Value OFF
* This cannot be specified for assign numbers 9—16.
* The range available for setting will depend on the selected target.
* If you set the "minimum value" above the "maximum value," the
direction of parameter change will be reversed.
* Ifafter setting the "minimum" and "maximum" values you then change
the target, the settings may change. After changing the target, check
that the target value range has not changed.
Source: the controller that will control
the parameter
Selection for the controller (source) that will control the target
parameter.
The following controllers can be selected as sources.
Assign 1 Source
MIDI CTL# 7
*Anexpression pedal (optional: EV-5, FV-300L (BOSS) + PCS-33)
connected to the EFFECT REMOTE/EXP PEDAL Jack
eA foot switch (optional: FS-1, DP-2, FS-SU (BOSS), FS-5L (BOSS),
etc.) connected to the Control 1/2 jack
*Aftertouch messages from an external MIDI device
*Pitch Bend messages from an external MIDI device
«Control Change messages (1-31, 64-95) from an external MIDI
device
22
Source Mode:
the result of operating a foot switch
This setting determines how the target parameter value will be
affected when you operate a momentary-type foot switch (op-
tional: DP-2, FS-5U (BOSS), etc.).
Sere
Harmal
Normal: The parameter will normally be off (minimum value),
and will be on (maximum value) only while the foot
switch is depressed.
Toggle: Тһе parameter will switch between off (minimum) and
on (maximum) value each time you press the foot
switch.
* If you have connected a latch-type foot switch (optional: FS-1, FSSL
(BOSS), etc.) or if you have not selected a foot switch as the controller,
this setting should be left at "Normal."
(Momentary-type and latch-type foot switches)
If you use a foot switch to switch Effect On/Off
You may use either a momentary-type or a latch-type foot switch.
When using a momentary-type, select "Toggle." When using a
latch-type, select "Normal." In either case, Effect On/Off will
alternate each time you press the foot switch.
If you want an effect to become stronger while you
depress a foot switch, or for the effect fo be on only
while the foot switch is depressed
Use a momentary-type foot switch, and select "Normal." In this
case, the setting (on/off) will depend on whether the foot switch is
depressed or not. This type of operation is not possible with a latch-
type foot switch.
Control Value Range
If a continuously variable controller such as an expression pedal
or pitch bend lever has been selected as the control source, you
can specify the range of values which will affect the target
parameter. The value of the target parameter will not be affected
by controller movements outside this specified range, but will
remain at the "maximum" or "minimum" value.
* This cannot be set for assign numbers 9—16.
ишге
и
Lo Й
Sure
Hi 127