Using The Tuner Ызыра Нкан; Switching To The Tuner Function; The Tuning Display; Tuning Procedure - Roland GP-100 Owner's Manual

Using the Tuner
The GP-100 has a built-in chromatic tuner. You can tune your
instrument quickly without having to change connections.
Switching to the Tuner Function
Here's how to use the built-in tuner to tune your guitar. While the
tuner function is being used, the GP-100 will be muted, and the
guitar sound will not be output.
* Itisalso possible to output the effect sound even while the tuner is being
used. For details refer to "Volume during tuning" (p. 14).
«Switching from the Front Panel»
Each time you press the [TUNER] button the Tuner function will
alternate on/off. When the tuner is on, the button indicator will
light, and the tuner display will appear.
«Switching with a Foot Switch»
If an FS-SU or FS-5L is connected to the CONTROL jack, you can
Switch the TUNER on/off with the foot switch. The same as when
you press the [TUNER] button, the button indicator will light when
the tuner is on.
* If you wish to use this function, make the following settings. For
details refer to "CONTROL 1/2 Jack" (p. 28).
«UTILITY»
CONTROL 1 Jack: Assignable
or
CONTROL 2 Jack: Assignable
<Control Assign>
Target: TUNER On/Off
Source: CONTROL 1 or CONTROL 2
(set to match the UTILITY setting)
Source Mode: Toggle (:FS-5U) or Normal (:FS-5L)
(set to match the foot switch that is connected)
(Source Act.Range Lo 0)
(Source Act.Range Hi 127)
<Switching with an FC-200 MIDI Foot Controller>
If an FC-200 MIDI foot controller (optional) is connected, you can
use pedal operations to switch the Tuner on/off. For details refer to
"GP-100 Operation Using the FC-200" (p. 58).
«Switching with MIDI Messages»
MID! Control Change messages can be used to switch the Tuner
on/off. For details refer to "Control Assign Settings" (p. 21).
Section 1 Try out the GP-100
The Tuning Display
The GP-100's tuner shows the note name in the upper line of the
display, and the lower line shows a graphical tuning guide to
indicate the sharpness or flatness of the note.
Note Names
Tuning Guide
Tuning Procedure
(Procedure)
1 Play a single unfretted note on the string you wish to tune.
The note name closest to the string you played will appear in
the display.
2 Adjust the tuning until the note name of the string you played
appears in the display.
6th 4th | 3rd 1st
String String | String String
3 while watching the tuning guide, adjust the tuning until only
the middle indicator(Tuned) is lit.
Too High
Too Low
4 Repeat steps 1—3 to tune all the strings.
* When tuning a guitar that has a tremolo arm, tuning one string may
cause the other strings to go out of tune. In such cases, first tune the
strings to the approximate pitch (so that the note name is displayed),
and then keep tuning each string until they are all in tune.
13