Section 5 - Roland GP-100 Owner's Manual

Section 2 Modifying various settings
Setting the Effect Unit Connection
Order
You can rearrange the order in which the effects making up the
algorithm are connected in any way you please, except for
feedbacker and reverb. It is also possible to select parallel output
for reverb and the effect connected immediately before reverb.
* Note, however, that the connection order for the DUAL algorithm is
fixed.
(Procedure)
1 Use the PARAMETER knob to move the cursor (underline) to
the name of the effect whose order you wish to change.
2 Rotate the VALUE knob to change the order of the specified
effect, until it appears in the desired connection location.
З Repeat steps 1—2 to place the effects in the desired order.
(Reverb Connection Order)
itis not possible to modify the connection order of the reverb. Also,
the only way to connect an effect after the reverb is to use the send/
return or a foot volume.
(Reverb Parallel Output)
You can select parallel output for reverb and the effect positioned
immediately before the reverb. Move the cursor to reverb, and
rotate the VALUE knob to select series connection or parallel
connection.
* If the reverb is output in parallel, the Direct Level setting will be "0"
and the parameter will not be displayed.
tefl +elE RI
OUTPUT
OUTPUT
20
Effect Sound Settings
Each of the effects in an algorithm has a variety of parameters.
Create your new effect sound by modifying the settings of these
parameters.
(Procedure)
ranameran "VALERY
1 Use the PARAMETER knob to select the parameter whose
value you wish to modify. By pressing the PARAMETER knob
while you rotate it, you can jump to the first parameter of each
effect.
2 Use the VALUE knob to modify the value. By pressing the
VALUE knob while you rotate it, you can make the value
change faster.
З Repeat steps 1—2 to create your new effect sound.